Cart

0 item(s)
ASK OUR EXPERTS 800-209-9598

Welcome to our online store!

ARC TEMPLATE

Quick Overview

IMPORTANT

  • Proper axle torquing procedures
  • It is imperative that you follow the manufacturer's specifications to insure the axle is installed correctly. Failure to follow the manufacture's procedures can result in failure of your new axle & hub bearing.
  • One of the most common mistakes during installation is improper torque of the axle spindle nut. Over torque of the axle spindle nut can cause the bearing and axle to overheat , which will dramatically reduce the life of your new axle & hub bearing assembly.
  • While it may appear to be easier to use an impact wrench , it is not recommended. A torque wrench is !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
  • Every vehicle has specific torque specifications , and it will be listed after the axle part number.
  • New axle failure may also be caused buy broken or worn engine or transmission mounts.
SKU: 280F8D57-B65C-4238-8636-86B82EBD4986
AdID: 11143

Availability: 500 item(s)

$53.99

Details

This is a brand New CV DRIVE SHAFT , AXLE THAT FITS , NISSAN & INFINITI
DRIVERS SIDE
2000 2001 Maxima & I30 , with Manual transmission
NOTE , this axle comes with the ABS trigger wheel
PART # 1 / NCV53108
TORQUE SPEC. refer to oem for ft lbs
All of our CV shafts come brand new, this means there is no core charge to deal with. Also a LIFE TIME WARRANTY, this is an amazing deal.
FRONT WHEEL DRIVEAXLES
Each unit is completely disassembled and cleaned to allow for inspection of entire unit. Arc uses the finest CVS computer controlled precision diamond grinding on all C.V. housings, races and cages to maintain rigid OEM internal geometric specifications, or replaced with new (U.S. made) Rockford Parts. Center shafts are tested for run-out to insure full radius straightness and replaced when necessary. All two piece shafts are replaced with a solid one. New steel balls are installed to insure exact fit.
New Rockford boots that remain flexible and resist splitting under extreme hot and cold temperatures and oeitker clamps are installed on every unit. Essential hardware including dust shields, slingers and nuts are replaced with new OEM quality parts as required. The threads are chased and splines pre-checked for easy installation. The unit is remanufactured to meet or exceed OEM specifications.